The Embedded I/O Company

TCP260

Dual PMC Carrier for 6U CompactPCI (J3/J5 I/O)

Application Information

The TCP260 is a standard 6U CompactPCI carrier that

provides front I/O and rear I/O for up to two single width

PMC modules.

The transparent PCI to PCI Bridge is used as the PCI

bridging device between the primary CompactPCI bus and

the on board secondary PCI bus where the two PMC slots

reside.

Supported PCI bus data widths are 32 bit and 64 bit.

Supported PCI bus frequencies are 33 MHz and 66 MHz.

The TCP260 supports standard PMC front I/O and

CompactPCI rear I/O. The PMC slot 1 I/O lines are

connected directly to the CompactPCI connector J3. The

PMC slot 2 I/O lines are connected directly to the

CompactPCI connector J5.

The TCP260 also provides hot swapping capability. The

TCP260 on board hot swap controller controls the

installation and reinstallation process of the TCP260

without powering down the CompactPCI system.

The TCP260 carrier complies with the PICMG 2.0

Revision 3.0 CompactPCI specification.

The TCP260 is available in extended temperature range

as TCP260-10R-ET and TCP260-11R-ET.

Technical Information

 Standard 6U 32/64 bit CompactPCI module

conforming to PICMG 2.0 R3.0

 PCI 2.2 compliant interface

 Two PMC sites conforming to PMC standard

 Board size: 160 mm x 233.35 mm

 Front panel I/O

 CompactPCI rear I/O : Connector J3 and J5

 PCI Interface : 33 / 66 MHz; 32 / 64 bit

 PCI-to-PCI bridge Pericom PI7C8154

 CompactPCI hot swap conforming to PICMG 2.1 R2.0

 5V and 3.3V signaling

 Temperature range: 0°C to +70°C (TCP260-10R/-

11R) and -40°C to +85°C (TCP260-10R-ET/-11R-ET)

TEWS TECHNOLOGIES GmbH keeps the right to change technical specification without further notice.

All trademarks mentioned are property of their respective owners.

Issue 1.0.1

2017-08-17

TEWS TECHNOLOGIES GmbH

Am Bahnhof 7

25469 Halstenbek, Germany

Phone: +49 (0) 4101 4058 0

Fax: +49 (0) 4101 4058 19

e-mail: info@tews.com

www.tews.com