M48T35AV_07 datasheet(11/28 Pages) STMICROELECTRONICS

11 / 28 page

M48T35AV

Operation modes

11/28

Table 4.

Write mode AC characteristics

2.3

Data retention mode

With valid VCC applied, the M48T35AV operates as a conventional BYTEWIDE™ static

RAM. Should the supply voltage decay, the RAM will automatically power-fail deselect, write

protecting itself when VCC falls within the VPFD (max), VPFD (min) window (see Figure 13,

Table 10, and Table 11 on page 21). All outputs become high impedance, and all inputs are

treated as “don't care.”

Note:

A power failure during a WRITE cycle may corrupt data at the currently addressed location,

but does not jeopardize the rest of the RAM's content. At voltages below VPFD (min), the

user can be assured the memory will be in a write protected state, provided the VCC fall time

is not less than tF. The M48T35AV may respond to transient noise spikes on VCC that reach

into the deselect window during the time the device is sampling VCC. Therefore, decoupling

of the power supply lines is recommended.

When VCC drops below VSO, the control circuit switches power to the internal battery which

preserves data and powers the clock. The internal button cell will maintain data in the

M48T35AV for an accumulated period of at least 7 years when VCC is less than VSO. As

system power returns and VCC rises above VSO, the battery is disconnected and the power

supply is switched to external VCC. Write protection continues until VCC reaches VPFD (min)

plus trec (min). E should be kept high as VCC rises past VPFD (min) to prevent inadvertent

WRITE cycles prior to processor stabilization. Normal RAM operation can resume trec after

VCC exceeds VPFD (max).

Symbol

Parameter(1)

Valid for ambient operating temperature: TA = 0 to 70°C; VCC = 3.0 to 3.6V (except where noted).

M48T35AV

Unit

Min

Max

tAVAV

WRITE cycle time

100

tAVWL

Address valid to WRITE enable low

tAVEL

Address valid to chip enable low

tWLWH

WRITE enable pulse width

tELEH

Chip enable low to chip enable high

tWHAX

WRITE enable high to address transition

tEHAX

Chip enable high to address transition

tDVWH

Input valid to WRITE enable high

tDVEH

Input valid to chip enable high

tWHDX

WRITE enable high to input transition

tEHDX

Chip enable high to input transition

tWLQZ

(2)(3)

CL = 5pF.

If E goes low simultaneously with W going low, the outputs remain in the high impedance state.

WRITE enable low to output Hi-Z

tAVWH

Address valid to WRITE enable high

tAVEH

Address valid to chip enable high

tWHQX

(2)(3)

WRITE enable high to output transition

M48T35AV Datasheet(PDF) 11 Page - STMicroelectronics

M48T35AV Datasheet(HTML) 11 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datasheet Download

Link URL