| Electronic Components Datasheet Search |
|
LP3990MF-2.5/NOPB Datasheet(PDF) 14 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
LP3990MF-2.5/NOPB Datasheet(HTML) 14 Page - Texas Instruments |
|
14 / 30 page ![]() TIME (50 2s/DIV) IL = 150 mA TIME (20 2s/DIV) 150 1 CIN = 1 2F COUT = 0.47 2F LP3990 SNVS251J – MAY 2004 – REVISED SEPTEMBER 2014 www.ti.com To ensure proper operation, the signal source used to drive the EN input must be able to swing above and below the specified turn-on/off voltage thresholds listed in the Electrical Characteristics section under VIL and VIH. An internal 1-M Ω pull-down resistor ties the EN input to ground, ensuring that the device remains off if the EN pin is left open circuit. 8.2.3 Application Curves Figure 16. Load Transient Figure 15. Enable Start-Up Time 9 Power Supply Recommendations This device is designed to operate from an input supply voltage range of 2 V to 6 V. The input supply should be well regulated and free of spurious noise. To ensure that the LP3990 output voltage is well regulated, the input supply should be at least VOUT + 0.5 V, or 2 V, whichever is higher. A minimum capacitor value of 1-μF is required to be within 1 cm of the IN pin. 10 Layout 10.1 Layout Guidelines The dynamic performance of the LP3990 is dependant on the layout of the PCB. PCB layout practices that are adequate for typical LDO's may degrade the load regulation, PSRR, noise, or transient performance of the LP3990. Best performance is achieved by placing CIN and COUT on the same side of the PCB as the LP3990, and as close as is practical to the package. The ground connections for CIN and COUT should be back to the LP3990 ground pin using as wide, and as short, of a copper trace as is practical. Connections using long trace lengths, narrow trace widths, and/or connections through vias should be avoided. These will add parasitic inductances and resistance that results in inferior performance especially during transient conditions. A Ground Plane, either on the opposite side of a two-layer PCB, or embedded in a multi-layer PCB, is strongly recommended. This Ground Plane serves two purposes : 1) Provide a circuit reference plane to assure accuracy, and 2) provides a thermal plane to remove heat from the LP3990 WSON package through thermal vias under the package DAP. 14 Submit Documentation Feedback Copyright © 2004–2014, Texas Instruments Incorporated Product Folder Links: LP3990 |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |