Multifunction Preset Counter

H7CX (Counter Function)

C-107

I Operating Procedures (Counter Function)

Settings for Basic Operations

Note: Set to one-shot output 2 time when using as a 2-stage counter

or batch counter.

Easy Confirmation of Switch Settings Using Indicators

The ON/OFF status of the DIP switch pins can be

confirmed using the front display. For details, refer to page 124.

Note: 1. Be sure to set pin 1 of the DIP switch to ON. If it is set to OFF, the DIP switch settings will not be enabled.

2. Changes to DIP switch settings are enabled when the power is turned ON.

3. When setting input modes, output modes, or output times that cannot be set with the DIP switch, all of the settings have to be made using

the operation keys. For details on the setting methods, refer to page 108. When making settings using the operation keys, be sure to set

pin 1 of the DIP switch to OFF.

1234567

8

OFF

ON

Settings for basic functions can be performed with just the DIP switch.

Be sure to set pin 1 to ON.

Note: All of the pins are factory-set to OFF.

Item

OFF

ON

1

DIP switch settings en-

able/disable

Disabled

Enabled

2

Counting speed

30 Hz

5 kHz

3

Input mode

UP (increment) DOWN (decre-

ment)

4

Output mode

Refer to the table on the right.

5

6

One-shot output time

(See note.)

0.5 s

0.05 s

7

Reset input signal width

20 ms

1 ms

8

NPN/PNP input mode

NPN

PNP

Pin 4

Pin 5

Output mode

OFF

OFF

N

ON

OFF

F

OFF

ON

C

ON

ON

K-1

Switching to Total and Preset Counter, Batch Counter, and Dual Counter Operation (See note.)

Configuration selection mode

Run mode

Power ON

(Tachometer)

Note: The configurations that can be selected vary with the model.

+

Advanced-Function Settings

The H7CX is factory-set to the 1-stage

counter (2-stage counter for H7CX-AW

@/-

A4W

@ models) configuration. To change to

a different configuration, use the procedure

shown on the right. For details, refer to

page 39.

Note: This includes changing to the 2-

stage counter (or 1-stage counter)

configuration.

Hold down for

1 s min. (See note.)

(1-stage

counter)

(2-stage

counter)

(Total and

preset counter)

(Batch

counter)

(Dual

counter)

After making DIP switch settings for basic operations, advanced functions (see note) can be added using the operation keys.

For details, refer to page 22.

Note: Advanced functions consist of the dual count calculating mode, output 1 time (for 2-stage counter), decimal point position,prescale value, display

color, output allocation, and key protect level.

MODE

1

Note: The

key must be pressed before the

key.

MODE

1

Select the configuration using the

and

keys (

key with 6-digit models).