If you need Bee1 working with the software serial port, and Bee2 working with the hardware serial

port, you can change the jumpers and switches like so:

Sample Code

/*

# This sample code is used to test the Bees shield.

# Editor : Mickey

# Ver

: 1.0

# Product: Bees shield

# SKU

: DFR0210

# The circuit:

software RX is digital pin 2 (connect to TX of Bee1 device)

software TX is digital pin 3 (connect to RX of Bee1 device)

*/

#include <SoftwareSerial.h>

SoftwareSerial mySerial(2, 3); // UNO RX -- Bee TX, UNO TX -- Bee RX

void setup()

{

Serial.begin(115200);

mySerial.begin(115200);

delay(50);