Connection Diagram

Fig1: cheapDuino Pin Out

Note:



When plugin the fpc programming cable to DFRobot FPC programmer and cheapDuino, please the

blue side facing upward.

Example Code



Choose the right com port of your programmer in the Arduino IDE first.



Choose "Arduino NG or older /w ATmega8" in the "Boards" option.



Then just upload your arduino sketch to the cheapDuino. The "Blink" sketch will be used to drive the

LED connected to the D13 pin onboard.

const int ledPin =

13;

// the number of the LED pin on the cheapDuino

// Variables will change:

int ledState = LOW;

// ledState used to set the LED

long previousMillis = 0;

// will store last time LED was updated

// the follow variables is a long because the time, measured in miliseconds,