PI3USB411 datasheet(2/16 Pages) PERICOM

2 / 16 page

PI3USB411

3.3V, USB 2.0 High-Speed Signal Switch

with Low THD Channels for Audio Signals

PS8817A

06/06/06

DC Electrical Characteristics for USB 2.0 Switching over Operating Range

(only related to pins 1, 2, 4, 14, 15)

(TA = –40°C to +85°C, VCC = 3.3V ±10%)

Paramenter

Description

Test Conditions (1)

Min.

Typ.(2) Max.

Units

VIH

Input HIGH Voltage

Guaranteed HIGH level

VCC = 4.2V

2.0

VCC = 3.3V

1.6

VIL

Input LOW Voltage

Guaranteed HIGH level

0.8

VIK

Clamp Diode Voltage

VCC = Max.,

IIN = –18mA

-0.7

-1.2

IIH

Input HIGH Current

VCC = Max.,

VIN = VCC

±5

μA

IIL

Input LOW Current

VCC = Max.,

VIN = GND

±5

RON

Switch On-Resistance(3)

VCC = Min.,

1.25V ≤ VIN ≤ VCC,

IIN = –40mA

6.5

Ω

RFLAT(ON)

On-Resistance Flatness(4)

VCC = Min., VIN @

1.5V and VCC IIN =

-40mA

1.0

ΔRON

On-Resistance match from

center ports to any other

port(4)

VCC = Min.,

1.5V ≤ VIN ≤ VCC,

IIN = -40mA

0.9

Storage Temperature ......................................... –65°C to +150°C

Supply Voltage to Ground Potential ....................–0.5V to +4.4V

DC Input Voltage .................................................–0.5V to +5.5V

DC Output Current ........................................................... 120mA

Power Dissipation ................................................................ 0.5W

Note: Stresses greater than those listed under MAXIMUM RAT-

INGS may cause permanent damage to the device. This is a stress

rating only and functional operation of the device at these or any other

conditions above those indicated in the operational sections of this

specification is not implied. Exposure to absolute maximum rating

conditions for extended periods may affect reliability.

Maximum Ratings

(Above which useful life may be impaired. For user guidelines, not tested.)

Capacitance for USB 2.0 Switching (TA = 25°C, f = 1 MHz) (only related to pins 1, 2, 4, 14, 15)

Parameters(4)

Description

Test Conditions(1)

Typ.(2)

Max.

Units

CIN

Input Capacitance

VIN = 0V

2.0

3.0

COFF

Port I Capacitance, Switch OFF

4.0

CON

Switch Capacitance, Switch ON

7.5

9.5

Notes for Page 2:

1. For max. or min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.

2. Typical values are at VCC = 3.3V, TA = 25°C ambient and maximum loading.

3. Measured by the voltage drop between DI and DO pins at indicated current through the switch. ON-resistance is determined by the lower of the

voltages on the two (DI & DO) pins.

4. This parameter is determined by device characterization but is not production tested.

06-0078

PI3USB411 Datasheet(PDF) 2 Page - Pericom Semiconductor Corporation

PI3USB411 Datasheet(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Datasheet Download

Link URL