PCF2131 datasheet(20/31 Pages) NXP

20 / 31 page

NXP Semiconductors

UM11597

PCF2131-ARD evaluation board

Figure 12. The assembly PCF2131-ARD daughterboard, IMX8MMINI-IARD interposer board,

and i.MX 8M Mini LPDDR4 EVK, before getting to start

To configure and operate the setup:

1. Insert the PCF2131-ARD onto the IMX8MMINI-IARD interposer board Arduino

connectors (located on the top side)

2. Attach IMXMMINI-IARD connector plug J1 (located on the bottom of the board) into

J1003 expansion board located on the top side of i.MX 8M Mini LPDDR4 EVK (see

Figure 12

3. Power-up the EVK board using a USB Type-C cable attached to PORT 2

4. Connect the EVK to the PC, using a USB Micro-B cable, attached to J901 debug port

5. Place SW101 in ON position to power-up the boards

6. Install the MIMXRT1050 target firmware (UM11581, Arduino shields GUI and firmware

installation manual)

7. Install GUI application on the PC (see the instruction file referred in the above step)

8. Open the GUI application to operate the device from the PC. For details regarding

GUI operation see Section 7

UM11597

All information provided in this document is subject to legal disclaimers.

User manual

Rev. 1.0 — 15 September 2021

20 / 31

PCF2131 Datasheet(PDF) 20 Page - NXP Semiconductors