4

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

13. NEVER use the tool if it is defective or operating abnormally.

14. This air tool should be serviced at regular intervals by qualified service

personnel.

15. AVOID damaging the air tool by applying excessive force of any kind.

16. ALWAYS maintain the air tool with care. Keep it clean for the best and safest

performance.

17. ALWAYS ensure the workpiece is firmly secured leaving both hands free to

control the tool.

18. ALWAYS ensure the tool has stopped before putting it down after use.

19. ALWAYS ensure that any attachments are correctly fastened before

connecting the tool to the power supply

20. DO NOT force or misuse the air tool. It will do a better and safer job at the

rate for which it was designed.

21. Quick change couplings should not be located at the tool. They add

weight and could fail due to vibration.

22. DO NOT remove any labels. Damaged labels should be replaced.

23. This tool vibrates with use. Vibration may be harmful to your hands or arms.

Stop using the tool if discomfort, a tingling feeling or pain occurs. Seek

medical advice before resuming use.

SANDER-SPECIFIC SAFETY RULES

1. Inspect the sanding pad before use. DO NOT use if cracked or broken.

Check that the rated speed of the backing pad is at least as high as that

of the machine.

2. AVOID contact with the moving sanding pad and wear suitable gloves to

protect the hands.

3. NEVER start the tool unless the abrasive pad is applied to the workpiece.

4. Beware of potentially explosive atmospheres being caused by dust / fumes

resulting from sanding and use dust extraction systems where possible.

5. ALWAYS wear a face mask when using the sander as protection from

airborne particles of sanded material. Avoid disturbing existing dust and

minimise the scattering of dust in the workplace environment. Take steps to

control the dust at the point of emission.

TRANSPORTATION

1. NEVER carry the tool by the air hose or with your finger on the trigger.

2. When not in use the tool should be disconnected from the air supply and

stored in a dry place out of the reach of children.