DLS360 datasheet(14/40 Pages) CLARKE

14 / 40 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

REMOVE THE TRAVEL PLUGS BEFORE USE.

1. Using the 17mm spanner, remove the

travel plugs, as shown.

2. Take from the small bag attached the

two red topped black breather filler

plugs which need to be fitted in their

place, as shown.

• The breather filler plugs must only

be inserted finger tight.

SAFETY FEATURES

Bypass mode: In bypass mode, the pump recirculates the water because the trigger

of the spray gun is not being pulled. If the unit is left unused for more than two

minutes, the water temperature will rise to a dangerous level and could damage

internal components of the pump. If this is the case, the Thermal Relief Valve will

automatically engage. If the gun will not be used for a longer period or the thermal

relief valve does not operate, switch off the engine.

Thermal Relief Valve: In an effort to

prevent damage, pumps are equipped

with a thermal relief valve. This valve will

open when the temperature inside the

pump becomes too high. The valve will

then release a gush of water in an effort

to lower the temperature inside the

pump. Immediately after this occurs, the

valve will close.

DLS360 Datasheet(PDF) 14 Page - Clarke International