www.i-led.co.uk

Intelligent LED Solutions, Unit 2, Berkshire Business Centre, Berkshire Drive, Thatcham, Berkshire, RG19 4EW

Telephone: +44 (0)1635 294606 Email: info@i-led.co.uk Web: www.i-led.co.uk

A division of Intelligent Group Solutions Ltd

9

Product

Non Adhesive

Single Sided Adhesive

Double Sided Adhesive

25x15mm Strip

ILA-TIM-STRIP-25x15-0A

ILA-TIM-STRIP-25x15-1A

ILA-TIM-STRIP-25x15-2A.

58x58mm Square

ILA-TIM-SQUARE-58X58-0A

ILA-TIM-SQUARE-58X58-1A

ILA-TIM-SQUARE-58X58-2A.

Other sizes are available, including customised parts

Assembly Information

z

The mounting of the OSLON® 1 PowerStar IR has to be on a metal Heatsink.

z

In order to optimise the thermal management, the metal surface needs to be clean (dirt and oil free) and planar for

the best contact with the LED module. A thermal grease or heat transfer material is highly recommended.

Safety Information

z

The LED module itself and all its components must not be mechanically stressed.

z

Assembly must not damage or destroy conducting paths on the circuit board.

z

The mounting of the module is carried out by attaching it at the mounting holes. Metal mounting screws must be

insulated with synthetic washers to prevent circuit board damage and possible short circuiting.

z

To avoid mechanical damage to the connecting cables, the boards should be attached securely to the intended

substrate. Heavy vibration should be avoided.

z

Observe correct polarity!

z

Depending on the product, incorrect polarity will lead to emission of red or no light. The module can be destroyed!

z

Pay attention to standard ESD precautions when installing the OSLON® 1 PowerStar IRs.

z

The OSLON® 1 PowerStar IRs, as manufactured, have no conformal coating and therefore offer no inherent

protection against corrosion.

z

Damage by corrosion will not be accepted as a materials defect claim. It is the user’s responsibility to provide

suitable protection against corrosive agents such as moisture and condensation and other harmful elements.

z

For outdoor usage, a housing is definitely required to protect the board against environmental influences. The

design of the housing must correspond to the IP standards in the application. It is also the responsibility of the user

to ensure any housings or modifications keep the Tc junction temperature to within stated ranges.

z

To also ease the luminaire/installation approval, electronic control gear for LED or LED modules should carry the

CE mark and be ENEC certified. In Europe the declarations of conformity must include the following standards: CE:

EC 61374-2-13, EN 55015, IEC 61547 and IEC 61000-3-2 - ENEC: 61374-2-13 and IEC/EN 62384.

z

Depending on the mode of operation, these devices emit highly concentrated non visible infrared light which can be

hazardous to the human eye. Products which incorporate these devices have to follow the safety precautions given

in IEC 60825-1 and IEC 62471.

For further information please contact ILS

The values contained in this data sheet can change due to technical innovations. Any such changes will be made

without separate notification.