High-voltage contactor

B88269X*

Gas-filled contactor for high-voltage DC switching

HVC50

PPD AB PD / PPD AB PM

Version: 01 / 2024-10-14

Please read Cautions and warnings and

Page 8 of 13

Important notes at the end of this document.

Accessory

Mating connector plug

To order if required:

Ordering code

B88269X9960C101 (10 pcs. in a box)

Notes:

1

All physical dimensions specified in the datasheet follow the general tolerances of the datasheet drawing.

2

The recommended cross section refers to pure copper. In other cases it must be matched to actual current, conductor

material properties and operation temperature.

3

Referring to IEC 60068-2-27

4

Referring to IEC 60068-2-64

5

Freezing or condensing must be avoided.

6

Valid for base-model without accessory, other configurations will lead to deviations.

7

The specified values apply to unused contactors acc. to IEC 61810-1.

8

Referring to IEC 60947-4-1, 6000 operations make & break

9

Referring to IEC 60947-4-1, 50% of operations in positive and 50% in negative direction.

10

Detection limit 10 mA

11

Measured at rated control voltage UC including contact bouncing time.

12

Specified, referring to JIS C 5442 (temperature 15 °C to 35 °C, humidity 25% to 85% RH).

13

End of life is reached when insulation resistance is < 50 MΩ at 1000 V.

14

Duty cycle 50%, cycle duration 1 s, value represents B10 lifetime acc. to Weibull analysis.

15

Duty cycle 1%, cycle duration 600 s

16

Tested for resistive loads with τ ≤ 1 ms

17

No fire and no explosion will occur after this break.

18

At start up two coils are active. After ~200 ms one of the coils is switched off, leaving only a low power holding coil active.

19

Tolerance ±10% at thermal equilibrium