STR730FZ1T7 datasheet(50/52 Pages) STMICROELECTRONICS

Part #	STR730FZ1T7

Description	ARM7TDMI??32-bit MCU with Flash, 3x CAN, 4 UARTs, 20 timers, ADC, 12 comm. interfaces

PDF	52 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

50 / 52 page

Known limitations

STR73xFxx

50/52

Known limitations

7.1

Low power wait for interrupt mode

When the STR73x device is put in Low Power Wait For Interrupt mode (LPWFI), the Flash

goes into low power mode or power down mode, depending on the setting of the PWD bit in

the Flash Control Register 0 (default is ‘0’, Low Power mode). This default mode can create

excessive voltage conditions on the transistor gates and may affect the long term behavior

of the Low Power mode circuitry.

Workaround

There is no workaround. If Low Power Wait For Interrupt mode is used, it is strongly

suggested to configure the Flash to enter power down mode (bit PWD = ‘1’).

7.2

PLL free running mode at high temperature

When the STR73x device is operated and an ambient temperature (TA) of more than 55° C

and the main system clock (fMCLK) is sourced by the PLL in free running mode, the device

may not work properly.

Workaround

At high temperature (more than 55° C), it is recommended to use the internal RC oscillator

as a backup clock source rather than the PLL free running mode.

STR730FZ1T7 Datasheet(PDF) 50 Page - STMicroelectronics