STCF06 datasheet(20/33 Pages) STMICROELECTRONICS

20 / 33 page

I²C bus interface

STCF06

20/33

The Register address byte determines the first register in which the read or write operation

takes place. When the read or write operation is finished, the register address is

automatically increased.

8.7

Writing to multiple registers with incremental addressing

It would be unpractical to send several times the device address and the address of the

incremental addressing. When the data is written to a register, the address register is

automatically increased, so the next data can be sent without sending the device address

and the register address again. See Figure 9 below.

8.8

Reading from a single register

The reading operation starts with a START bit followed by the 7 bit device address of

STCF06. The 8th bit is the R/W bit, which is 0 in this case. STCF06 confirms the receiving of

the address + R/W bit by an acknowledge pulse. The address of the register which should

be read is sent afterwards and confirmed again by an acknowledge pulse of STCF06 again.

Then the master generates a START bit again and sends the device address followed by the

R/W bit, which is 1 now. STCF06 confirms the receiving of the address + R/W bit by an

acknowledge pulse and starts to send the data to the master. No acknowledge pulse from

the master is required after receiving the data. Then the master generates a STOP bit to

terminate the communication. See Figure 10

Figure 9.

Writing to multiple register with incremental addressing

DEVICE

ADDRESS

7 bits

ADDRESS OF

DATA i

DATA i+1

DATA i+2

DATA i+n

SDA LINE

DEVICE

ADDRESS

7 bits

ADDRESS OF

DATA i

DATA i+1

DATA i+2

DATA i+n

DEVICE

ADDRESS

7 bits

ADDRESS OF

DATA i

DATA i+1

DATA i+2

DATA i+n

SDA LINE

STCF06 Datasheet(PDF) 20 Page - STMicroelectronics

STCF06 Datasheet(HTML) 20 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33

Datasheet Download

Link URL