STLC5444 datasheet(8/17 Pages) STMICROELECTRONICS

8 / 17 page

tAHRH

tCLRL (Note 1)

tRHCH (Note 2)

tRLRH

tASRL

tRHRL

tRLDA

tRHDZ

Read Data

DATA

ALE

D97TL301A

tADDA

Figure 1a: Microprocessor Read Timing non multiplexed mode.

Notes:

1 - If tCLRL is negative, tRHRL,tRLRH,tAZRL, and tRLDA are measured from CS rather than RD.

2 - If tRHCH is negative, tRHRL,tRLRH and tRHDZ are measured from CS rather than RD.

When a read from the LER immediately follows a write to the LER a minimum of 1

µs is required between these operations.

tASWL

tCLWL (Note 1)

tWHCH (Note 2)

tWLWH

tWHWL

tDAWH

tWHDZ

Write Data

DATA

ALE

D97TL302A

INT

(Note 3)

tAHWH

Figure 2a: Microprocessor Write Timing non multiplexed mode.

Notes:

1 - If tCLWL is negative tWHWL and tWLWH are measured from CS rather than WR.

2 - If tWHCH is negative, tWHWL,tWLWH,tDAWH and tWHDZ are measured from CS rather than WR.

The propagation delay from the writing of the T/I bit to the effect on the INT pin is approximately 1

µs for both mask and enable operations.

STLC5444

8/17

STLC5444 Datasheet(PDF) 8 Page - STMicroelectronics