L6911E datasheet(18/34 Pages) STMICROELECTRONICS

Part #	L6911E

Description	5-Bit programmable step down controller with synchronous rectification

PDF	34 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

18 / 34 page

Device description

L6911E

18/34

5.8

Input capacitor

The input capacitor has to sustain the ripple current produced during the on time of the

upper MOS, so it must have a low ESR to minimize the losses.

The rms value of this ripple is:

Equation 11

Where D is the duty cycle. The equation reaches its maximum value with D = 0.5.

The losses in worst case are:

Equation 12

5.9

Compensation network design

The control loop is a voltage mode (Figure 9 on page 19) that uses a droop function to

satisfy the requirements for a VRM module, reducing the size and the cost of the output

capacitor.

This method "recovers" part of the drop due to the output capacitor ESR in the load

transient, introducing a dependence of the output voltage on the load current: at light load

the output voltage will be higher than the nominal level, while at high load the output voltage

will be lower than the nominal value.

Figure 8.

Output transient response without (a) and with (b) the droop function

rms

OUT

–

()

⋅

ESR I

rms

⋅

L6911E Datasheet(PDF) 18 Page - STMicroelectronics