STCF03I datasheet(15/33 Pages) STMICROELECTRONICS

Part #	STCF03I

Description	High power white LED driver with I2CTM interface

PDF	33 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

15 / 33 page

Introduction

STCF03I

15/33

7.4

Data validity

As shown in Figure 4, the data on the SDA line must be stable during the high period of the

clock. The HIGH and LOW state of the data line can only change when the clock signal on

the SCL line is LOW.

7.5

Start and stop conditions

Both DATA and CLOCK lines remain HIGH when the bus is not busy. As shown in Figure 5,

a start condition is a HIGH to LOW transition of the SDA line while SCL is HIGH. The stop

condition is a LOW to HIGH transition of the SDA line while SCL is HIGH. A STOP condition

must be sent before each START condition.

7.6

Byte format

Every byte transferred to the SDA line must contain 8 bits. Each byte must be followed by an

acknowledge bit. The MSB is transferred first. One data bit is transferred during each clock

Figure 4.

Data validity on the I2C Bus

Figure 5.

Timing diagram on I2C Bus

STCF03I Datasheet(PDF) 15 Page - STMicroelectronics