13192 datasheet(21/24 Pages) FREESCALE

21 / 24 page

Applications Information

MC13192 Technical Data, Rev. 3.3

Freescale Semiconductor

8.4

Low Power Considerations

•

Program and use the modem IO pins properly for low power operation

— All unused modem GPIOx signals must be used one of 2 ways:

– If the Off mode is to be used as a long term low power mode, unused GPIO should be tied

to ground. The default GPIO mode is an input and there will be no conflict.

– If only Hibernate and/or Doze modes are used as long term low power modes, the GPIO

should programmed as outputs in the low state.

— When modem GPIO are used as outputs:

– Pullup resistors should be provided (can be provided by the MCU IO pin if tied to the MCU)

if the modem Off condition is to be used as a long term low power mode.

– During Hibernate and/or Doze modes, the GPIO will retain its programmed output state.

— If the modem GPIO is used as an input, the GPIO should be driven by its source during all low

power modes or a pullup resistor should be provided.

— Digital outputs IRQ, MISO, and CLKO:

– MISO - is always an output. During Hibernate, Doze, and active modes, the default

condition is for the MISO output to go to tristate when CE is de-asserted, and this can cause

a problem with the MCU because one of its inputs can float. Program Control_B Register

07, Bit 11, miso_hiz_en = 0 so that MISO is driven low when CE is de-asserted. As a result,

MISO will not float when Doze or Hibernate Mode is enabled.

–IRQ - is an open drain output (OD) and should always have a pullup resistor (typically

provided by the MCU IO). IRQ acts as the interrupt request output.

NOTE

It is good practice to have the IRQ interrupt input to the MCU disabled

during the hardware reset to the modem. After releasing the modem

hardware reset, the interrupt request input to the MCU can then be enabled

to await the IRQ that signifies the modem is ready and in Idle mode; this can

prevent a possible extraneous false interrupt request.

– CLKO - is always an output. During Hibernate CLKO retains its output state, but does not

toggle. During Doze, CLKO may toggle depending on whether it is being used.

Shunt capacitance

max

Mode of oscillation

fundamental

1 User must be sure manufacturer specifications apply to the desired package.

2 A wider frequency tolerance may acceptable if application uses trimming at production final test.

3 A wider frequency stability may be acceptable if application uses trimming at production final test.

4 A wider aging tolerance may be acceptable if application uses trimming at production final test.

5 Higher ESR may be acceptable with lower load capacitance.

6 Lower load capacitance can allow higher ESR and is better for low temperature operation in Doze mode.

Table 10. MC13192 Crystal Specifications1 (continued)

Parameter

Value

Unit

Condition

13192 Datasheet(PDF) 21 Page - Freescale Semiconductor, Inc

13192 Datasheet(HTML) 21 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Datasheet Download

Link URL