H838532H datasheet(340/508 Pages) RENESAS

340 / 508 page

Section 10 Serial Communication Interface

Rev. 1.00 May 30, 2008 Page 320 of 484

REJ09B0436-0100

Figure 10.5 shows an example of a flowchart for initializing SCI3.

Start

End

Clear bits TE and

RE to 0 in SCR3

Set bits CKE1

and CKE0

Set data transfer

format in SMR

Set bits SPC31 and

SPC32 to 1 in SPCR

Set value in BRR

Wait

Yes

Set bits TIE, RIE,

and TEIE in SCR3,

and set bits

RE and TE to 1

in PMR7

Has 1-bit period

elapsed?

Set clock selection in SCR3. Be sure to

clear the other bits to 0. If clock output

is selected in asynchronous mode, the

clock is output immediately after setting

bits CKE1 and CKE0. If clock output is

selected for reception in synchronous

mode, the clock is output immediately

after bits CKE1, CKE0, and RE are

set to 1.

Set the data transfer format in the serial

mode register (SMR).

Write the value corresponding to the

transfer rate in BRR. This operation is

not necessary when an external clock

is selected.

Wait for at least one bit period, then set

bits TIE, RIE, and TEIE in SCR3,

and set bits RE and TE to 1 in PMR7.

Setting bits TE and RE enables the TXD3x

and RXD3x pins to be used. In asynchronous

mode the mark state is established when

transmitting, and the idle state waiting for

a start bit when receiving.

Figure 10.5 Example of SCI3 Initialization Flowchart

H838532H Datasheet(PDF) 340 Page - Renesas Technology Corp

H838532H Datasheet(HTML) 340 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL