H838532H datasheet(316/508 Pages) RENESAS

316 / 508 page

Section 10 Serial Communication Interface

Rev. 1.00 May 30, 2008 Page 296 of 484

REJ09B0436-0100

Bit 5: Transmit enable (TE)

Bit 5 selects enabling or disabling of the start of transmit operation.

Bit 5

Description

Transmit operation disabled*

1 (TXD pin is I/O port)

(initial value)

Transmit operation enabled*

2 (TXD pin is transmit data pin)

Notes: 1. Bit TDRE in SSR is fixed at 1.

2. When transmit data is written to TDR in this state, bit TDR in SSR is cleared to 0 and

serial data transmission is started. Be sure to carry out serial mode register (SMR)

settings, and setting of bit SPC31 or SPC32 in SPCR, to decide the transmission format

before setting bit TE to 1.

Bit 4: Receive enable (RE)

Bit 4 selects enabling or disabling of the start of receive operation.

Bit 4

Description

Receive operation disabled*

1 (RXD pin is I/O port)

(initial value)

Receive operation enabled*

2 (RXD pin is receive data pin)

Notes: 1. Note that the RDRF, FER, PER, and OER flags in SSR are not affected when bit RE is

cleared to 0, and retain their previous state.

2. In this state, serial data reception is started when a start bit is detected in asynchronous

mode or serial clock input is detected in synchronous mode. Be sure to carry out serial

mode register (SMR) settings to decide the reception format before setting bit RE to 1.

Bit 3: Reserved (MPIE)

Bit 3 is reserved.

H838532H Datasheet(PDF) 316 Page - Renesas Technology Corp