HD64F2149YV datasheet(497/1075 Pages) RENESAS

497 / 1075 page

Section 15 Serial Communication Interface (SCI, IrDA)

Rev. 3.00 Jan 18, 2006 page 469 of 1044

REJ09B0280-0300

<End>

[1]

Yes

Initialization

Start transmission

Read TDRE flag in SSR

[2]

Write transmit data to TDR and

set MPBT bit in SSR

Yes

Read TEND flag in SSR

[3]

Yes

[4]

Clear DR to 0 and set DDR to 1

Clear TE bit in SCR to 0

TDRE = 1?

All data transmitted?

TEND = 1?

Break output?

Clear TDRE flag to 0

SCI initialization:

The TxD pin is automatically

designated as the transmit data

output pin.

After the TE bit is set to 1, one

frame of 1s is output and

transmission is enabled.

SCI status check and transmit

data write:

Read SSR and check that the

TDRE flag is set to 1, then write

transmit data to TDR. Set the

MPBT bit in SSR to 0 or 1.

Finally, clear the TDRE flag to 0.

Serial transmission continuation

procedure:

To continue serial transmission,

be sure to read 1 from the TDRE

flag to confirm that writing is

possible, then write data to TDR,

and then clear the TDRE flag to

0. Checking and clearing of the

TDRE flag is automatic when the

DTC is activated by a transmit-

data-empty interrupt (TXI)

request, and data is written to

TDR.

Break output at the end of serial

transmission:

To output a break in serial

transmission, set the port DDR to

1, clear DR to 0, then clear the

TE bit in SCR to 0.

[1]

[2]

[3]

[4]

Figure 15.10 Sample Multiprocessor Serial Transmission Flowchart

HD64F2149YV Datasheet(PDF) 497 Page - Renesas Technology Corp

HD64F2149YV Datasheet(HTML) 497 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL