SH7052 datasheet(100/919 Pages) RENESAS

100 / 919 page

5.8

Usage Notes

5.8.1

Value of Stack Pointer (SP)

The value of the stack pointer must always be a multiple of four. If it is not, an address error will

occur when the stack is accessed during exception processing.

5.8.2

Value of Vector Base Register (VBR)

The value of the vector base register must always be a multiple of four. If it is not, an address error

will occur when the stack is accessed during exception processing.

5.8.3

Address Errors Caused by Stacking of Address Error Exception Processing

When the stack pointer is not a multiple of four, an address error will occur during stacking of the

exception processing (interrupts, etc.) and address error exception processing will start up as soon

as the first exception processing is ended. Address errors will then also occur in the stacking for

this address error exception processing. To ensure that address error exception processing does not

go into an endless loop, no address errors are accepted at that point. This allows program control

to be shifted to the address error exception service routine and enables error processing.

When an address error occurs during exception processing stacking, the stacking bus cycle (write)

is executed. During stacking of the status register (SR) and program counter (PC), the SP is

decremented by 4 for both, so the value of SP will not be a multiple of four after the stacking

either. The address value output during stacking is the SP value, so the address where the error

occurred is itself output. This means the write data stacked will be undefined.

SH7052 Datasheet(PDF) 100 Page - Renesas Technology Corp