6

5156E–SEEPR–10/08

AT24C01B

3.

Device Operation

CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an external device.

Data on the SDA pin may change only during SCL low time periods (see Figure 5-2 on page 8).

Data changes during SCL high periods will indicate a start or stop condition as defined below.

START CONDITION: A high-to-low transition of SDA with SCL high is a start condition which

must precede any other command (see Figure 5-3 on page 8).

STOP CONDITION: A low-to-high transition of SDA with SCL high is a stop condition. After a

read sequence, the stop command will place the EEPROM in a standby power mode (see Fig-

ure 5-3 on page 8).

ACKNOWLEDGE: All addresses and data words are serially transmitted to and from the

EEPROM in 8-bit words. The EEPROM sends a zero to acknowledge that it has received each

word. This happens during the ninth clock cycle.

STANDBY MODE: The AT24C01B features a low-power standby mode which is enabled: (a)

upon power-up and (b) after the receipt of the STOP bit and the completion of any internal

operations.

2-WIRE SOFTWARE RESET: After an interruption in protocol, power loss or system reset, any

2-wire part can be protocol reset by following these steps: (a) Create a start bit condition, (b)

Clock 9 cycles, (c) Create another start bit followed by a stop bit condition as shown below. The

device is ready for next communication after above steps have been completed.

Start bit

Stop bit

Start bit

Dummy Clock Cycles

SCL

SDA

12

3

8

9