DS033-3 July 2004

©2004 Reg. No. 227 4001, England

Page

3

•

The only connections required to the GPS Evaluation board are an RS232 data cable and power.

•

Jumper link JP5 should be fitted to set the baud rate to 4800 baud.

•

Please see the Microsoft Autoroute help file for information on configuring the software to work with a GPS

receiver

Evaluation Software

•

This provides an interface to the GPS receiver. Information including your current Location, a real time

position plot, the satellite locations and the satellite signal strength is displayed, as shown below.

•

The only connections required to the GPS Evaluation board are an RS232 data cable and power.

•

All jumper connections can be left open and the communications can be effected at 9600 baud.