V

V

V

V

Volta

olta

olta

olta

oltagggggeeeee

Comparator

Comparator

Comparator

Comparator

Comparator

AS111

AustinSemiconductor,Inc.reservestherighttochangeproductsorspecificationswithoutnotice.

3

AS111

Rev. 1.6 6/05

Austin Semiconductor, Inc.

NOTE: Do Not Ground Strobe Pin

NOTE 2: Typical input current is 50pV with inputs strobed off.

NOTE 3: Pin connections shown on schematic diagram and typical applications are for TO08 metal can package.

*Stresses greater than those listed under "Absolute Maximum

Ratings" may cause permanent damage to the device. This is

a stress rating only and functional operation of the device at

these or any other conditions above those indicated in the

operation section of this specification is not implied. Exposure

to absolute maximum rating conditions for extended periods

may affect reliability.

Total Supply Voltage (V

84

).............................................................36V

Output to Negative Supply Voltage (V

74

)....................................50V

Ground to Negative Supply Voltage (V

14

)...................................30V

Differential Input Voltage.............................................................±30V

Input Voltage

Output Short Circuit Duration..................................................10 sec

Lead Temperature (Soldering, 10 sec).......................................260°C

Voltage at Stobe Pin................................................................V

Note 4: This rating applies for ±15 supplies. The positive input voltage limit is 30V above the negative supply. The negative input voltage limit

is equal to the negative supply voltage or 30V below the positive supply, whichever is less.

Note 5: The maximum junction temperature of the AS111 is 150°C. For operating at elevated temperatures, devices in the TO08 package must

be derated based on a thermal resistance of 165°C/W, junction to ambient, or 20°C/W, junction to case. The thermal resistance of the dual-in-line

package is 110°C/W, junction to ambient.