AT90SCR100 datasheet(352/433 Pages) ATMEL

352 / 433 page

352

TPR0327AY–SMS–30Jan09

AT90SCR100

26.8

On-chip Debug Related Register in I/O Memory

26.8.1

OCDR – On-chip Debug Register

The OCDR Register provides a communication channel from the running program in the micro-

controller to the debugger. The CPU can transfer a byte to the debugger by writing to this

location. At the same time, an internal flag; I/O Debug Register Dirty – IDRD – is set to indicate

to the debugger that the register has been written. When the CPU reads the OCDR Register the

7 LSB will be from the OCDR Register, while the MSB is the IDRD bit. The debugger clears the

IDRD bit when it has read the information.

In some AVR devices, this register is shared with a standard I/O location. In this case, the OCDR

access to the OCDR Register. In all other cases, the standard I/O location is accessed.

Refer to the debugger documentation for further information on how to use this register.

26.9

Using the JTAG Programming Capabilities

Programming of AVR parts via JTAG is performed via the 4-pin JTAG port, TCK, TMS, TDI, and

TDO. These are the only pins that need to be controlled/observed to perform JTAG program-

ming (in addition to power pins). It is not required to apply 12V externally. The JTAGEN Fuse

must be programmed and the JTD bit in the MCUCR Register must be cleared to enable the

JTAG Test Access Port. See “MCUCR – MCU Control Register” on page 356.

The JTAG programming capability supports:

• Flash programming and verifying.

• EEPROM programming and verifying.

• Fuse programming and verifying.

• Lock bit programming and verifying.

If the Lock bits LB1 or LB2 are programmed, the OCDEN Fuse cannot be programmed unless

first doing a chip erase. This is a security feature that ensures no back-door exists for reading

out the content of a secured device.

The details on programming through the JTAG interface and programming specific JTAG

instructions are given in the section “Programming via the JTAG Interface” on page 385.

26.10 Bibliography

For more information about general Boundary-scan, the following literature can be consulted:

• IEEE: IEEE Std. 1149.1-1990. IEEE Standard Test Access Port and Boundary-scan

Architecture, IEEE, 1993.

• Colin Maunder: The Board Designers Guide to Testable Logic Circuits, Addison-Wesley,

1992.

Bit

7654

0x31 (0x51)

D7/IDRD

D6D5D4

D1D0

OCDR

Read/write

R/W

Initial value

0000

0x00

AT90SCR100 Datasheet(PDF) 352 Page - ATMEL Corporation

AT90SCR100 Datasheet(HTML) 352 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL