ATmega169P datasheet(215/393 Pages) ATMEL

215 / 393 page

215

8018N–AVR–08/09

ATmega169P

22. ADC - Analog to Digital Converter

22.1

Features

• 10-bit Resolution

• 0.5 LSB Integral Non-linearity

• ± 2 LSB Absolute Accuracy

• 13 µs - 260 µs Conversion Time (50 kHz to 1 MHz ADC clock)

• Up to 15 ksps at Maximum Resolution (200 kHz ADC clock)

• Eight Multiplexed Single Ended Input Channels

• Optional Left Adjustment for ADC Result Readout

• 0 - V

CC ADC Input Voltage Range

• Selectable 1.1V ADC Reference Voltage

• Free Running or Single Conversion Mode

• ADC Start Conversion by Auto Triggering on Interrupt Sources

• Interrupt on ADC Conversion Complete

• Sleep Mode Noise Canceler

22.2

Overview

The ATmega169P features a 10-bit successive approximation ADC. The ADC is connected to

an 8-channel Analog Multiplexer which allows eight single-ended voltage inputs constructed

from the pins of Port F. The single-ended voltage inputs refer to 0V (GND).

The ADC contains a Sample and Hold circuit which ensures that the input voltage to the ADC is

held at a constant level during conversion. A block diagram of the ADC is shown in Figure 22-1.

The ADC has a separate analog supply voltage pin, AVCC. AV

CC must not differ more than ±

0.3V from V

CC. See the paragraph ”ADC Noise Canceler” on page 221 on how to connect this

pin.

Internal reference voltages of nominally 1.1V or AVCC are provided On-chip. The voltage refer-

ence may be externally decoupled at the AREF pin by a capacitor for better noise performance.

The Power Reduction ADC bit, PRADC, in ”PRR – Power Reduction Register” on page 45 must

be written to zero to enable the ADC module.

ATmega169P Datasheet(PDF) 215 Page - ATMEL Corporation