ATmega328P datasheet(305/448 Pages) ATMEL

305 / 448 page

305

8161D–AVR–10/09

ATmega48PA/88PA/168PA/328P

E: Latch data (give PAGEL a positive pulse).

K: Repeat 3 through 5 until the entire buffer is filled.

L: Program EEPROM page

Set BS1 to “0”.

Give WR a negative pulse. This starts programming of the EEPROM page. RDY/BSY

goes low.

Wait until to RDY/BSY goes high before programming the next page (See Figure 27-4 for

signal waveforms).

Figure 27-4. Programming the EEPROM Waveforms

27.7.6

Reading the Flash

The algorithm for reading the Flash memory is as follows (refer to ”Programming the Flash” on

page 302 for details on Command and Address loading):

A: Load Command “0000 0010”.

G: Load Address High Byte (0x00 - 0xFF).

B: Load Address Low Byte (0x00 - 0xFF).

Set OE to “0”, and BS1 to “0”. The Flash word low byte can now be read at DATA.

Set BS1 to “1”. The Flash word high byte can now be read at DATA.

Set OE to “1”.

27.7.7

Reading the EEPROM

The algorithm for reading the EEPROM memory is as follows (refer to ”Programming the Flash”

on page 302 for details on Command and Address loading):

A: Load Command “0000 0011”.

G: Load Address High Byte (0x00 - 0xFF).

B: Load Address Low Byte (0x00 - 0xFF).

Set OE to “0”, and BS1 to “0”. The EEPROM Data byte can now be read at DATA.

Set OE to “1”.

RDY/BSY

RESET +12V

PAGEL

BS2

0x11

ADDR. HIGH

DATA

ADDR. LOW

DATA

ADDR. LOW

DATA

XA1

XA0

BS1

XTAL1

ATmega328P Datasheet(PDF) 305 Page - ATMEL Corporation

ATmega328P Datasheet(HTML) 305 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL