8

sCrimp Terminal Drawing Jig

q

How To Extract Crimp Terminal

PX50-SC-TC

CL250-0233-1

When the crimp terminal drawing jig is inserted and pushed from the fitting section of a connector as shown below, retainer lock of the

terminal will be released. Then please extract the cable. If the retainer is too lowered after extracting terminal, put it in a former position and

reinsert. Position and direction of the jig top to be inserted are as shown in the Figures below.

Be careful that any mistake will lead to the damage of terminal.

➀

➁

➂

➃

<WARNING>

✽ Insert the jig top into the peak of convex section on terminal hole.

The contents of this catalog are current as of date of publication. Contents are subject to change without notice for the purpose of improvements.

5-23,OSAKI 5-CHOME,SHINAGAWA-KU,TOKYO 141-8587,JAPAN

PHONE: 81-3-3491-9741, FAX: 81-3-3493-2933

http://www.hirose.com

http://www.hirose-connectors.com

®

Part No.

PX-50-SC-TC

CL No.

250-0233-1

RoHS

YES

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.