B206

DF4 Series

BPrecautions

1. Recommended

Flow: 250ç for 3 seconds

Manual soldering: 290±10ç for 2 seconds

■ If the cable neighboring the connector is bent and unstraightened, secure a large bending radius because the

Jacket will be broken by the solder heat and the contact wire will be exposed.The Jacket in this part will be tore.

■ After the soldering process. If a stress is applied to the cable in the state where the connector and the

cable has heat inside, the Jacket hold area will be loosen. Therefore, carry out the post-soldering

operation after the connector has returned to the room temperature..

2. Cleaning Condition

Refer to Nylon Connector Use Hand book.

Don't use a solvent such ass trichloroethylene which invades the cable Jacket. In addition, avoid heat

cleaning by a solvent.

3. Connection Condition

Refer to the Nylon Connector Use Hand book.

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.