PIC18F4580-ESLASHML datasheet(219/490 Pages) MICROCHIP

219 / 490 page

DS39637D-page 219

PIC18F2480/2580/4480/4580

18.4.8

I2C MASTER MODE START

CONDITION TIMING

To initiate a Start condition, the user sets the Start

Condition Enable bit, SEN (SSPCON2<0>). If the SDA

and SCL pins are sampled high, the Baud Rate Gener-

ator is reloaded with the contents of SSPADD<6:0>

and starts its count. If SCL and SDA are both sampled

high when the Baud Rate Generator times out (TBRG),

the SDA pin is driven low. The action of the SDA being

driven low while SCL is high is the Start condition and

causes the S bit (SSPSTAT<3>) to be set. Following

this, the Baud Rate Generator is reloaded with the

contents of SSPADD<6:0> and resumes its count.

When the Baud Rate Generator times out (TBRG), the

SEN bit (SSPCON2<0>) will be automatically cleared

by hardware, the Baud Rate Generator is suspended,

leaving the SDA line held low and the Start condition is

complete.

18.4.8.1

WCOL Status Flag

If the user writes the SSPBUF when a Start sequence

is in progress, the WCOL is set and the contents of the

buffer are unchanged (the write doesn’t occur).

FIGURE 18-19:

FIRST START BIT TIMING

Note:

If, at the beginning of the Start condition,

the SDA and SCL pins are already sam-

pled low, or if during the Start condition,

the SCL line is sampled low before the

SDA line is driven low, a bus collision

occurs, the Bus Collision Interrupt Flag,

BCLIF, is set, the Start condition is aborted

and the I2C module is reset into its Idle

state.

Note:

Because queueing of events is not

allowed, writing to the lower 5 bits of

SSPCON2 is disabled until the Start

condition is complete.

SDA

SCL

TBRG

1st bit

2nd bit

TBRG

SDA = 1,

At completion of Start bit,

SCL = 1

Write to SSPBUF occurs here

TBRG

hardware clears SEN bit

TBRG

Write to SEN bit occurs here

Set S bit (SSPSTAT<3>)

and sets SSPIF bit

PIC18F4580-E/ML Datasheet(PDF) 219 Page - Microchip Technology

PIC18F4580-E/ML Datasheet(HTML) 219 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL