56F8036 datasheet(2/164 Pages) FREESCALE

2 / 164 page

56F8036 Data Sheet, Rev. 6

Freescale Semiconductor

Document Revision History

Version History

Description of Change

Rev. 0

Initial public release.

Rev. 1

• In Table 10-4, added an entry for flash data retention with less than 100 program/erase

cycles (minimum 20 years).

• In Table 10-6, changed the device clock speed in STOP mode from 8MHz to 4MHz.

• In Table 10-12, changed the typical relaxation oscillator output frequency in Standby mode

from 400kHz to 200kHz.

• Changed input propagation delay values in Table 10-21 as follows:

Old values: 1

μs typical, 2 μs maximum

New values: 35 ns typical, 45 ns maximum

Rev. 2

In Table 10-20, changed the maximum ADC internal clock frequency from 8MHz to 5.33MHz.

Rev. 3

Added the following note to the description of the TMS signal in Table 2-3:

Note:

Always tie the TMS pin to VDD through a 2.2K resistor.

Rev. 4

• Changed the ITCN_BASE address In Table 5-3 (was $00 F060, is $00 F0E0).

•In Figure 5-10, moved the footnote marker (superscript 1) from bit 4 to “RESET”.

• Changed the STANDBY > STOP IDD values in Table 10-6 as follows:

Typical: was 290

μA, is 540μA

Maximum: was 390

μA, is 650μA

• Changed the POWERDOWN IDD values in Table 10-6 as follows:

Typical: was 190

μA, is 440μA

Maximum: was 250

μA, is 550μA

• Changed footnote 1 in Table 10-12 (was “Output frequency after application of 8MHz trim

value, at 125°C.”, is “Output frequency after application of factory trim”).

• Deleted the text “at 125°C” from Figure 10-5.

• Changed the maximum input offset voltage in Table 10-21 (was +/- 20 mV, is ±35 mV).

Rev. 5

• In Table 2-3, changed VCAP value from 4.7μF to 2.2μF.

• Revised Section 7, Security Features.

• Fixed miscellaneous typos.

Rev. 6

In the table Recommended Operating Conditions, removed the line “XTAL not driven by an

external clock“ from the characteristic:

“Oscillator Input Voltage High

XTAL not driven by an external clock

XTAL driven by an external clock source”

In the System Integration Module (SIM chapter), fixed typos.

Please see http://www.freescale.com for the most current Data Sheet revision.

56F8036 Datasheet(PDF) 2 Page - Freescale Semiconductor, Inc

56F8036 Datasheet(HTML) 2 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL