LTM4627EVPBF datasheet(15/28 Pages) LINER

15 / 28 page

LTM4627

4627f

top feedback resistor of the slave regulator in equal slew

rate or coincident tracking, then RTA is equal to RFB with

VFB = VTRACK. Therefore RTB = 60.4k, and RTA = 60.4k in

Figure 4.

In ratiometric tracking, a different slew rate maybe desired

for the slave regulator. RTB can be solved for when SR is

slower than MR. Make sure that the slave supply slew rate

is chosen to be fast enough so that the slave output voltage

will reach its ﬁnal value before the master output.

For example, MR = 1.5V/ms, and SR = 1.2V/ms. Then RTB

= 75k. Solve for RTA to equal 51.1k.

For applications that do not require tracking or sequenc-

ing, simply tie the TRACK/SS pin to INTVCC to let RUN

control the turn on/off. When the RUN pin is below its

threshold or the VIN undervoltage lockout, then TRACK/SS

is pulled low.

Figure 5. Output Voltage Coincident Tracking

APPLICATIONS INFORMATION

Overcurrent and Overvoltage Protection

The LTM4627 has overcurrent protection (OCP) in a short

circuit. The internal current comparator threshold folds

back during a short to reduce the output current. An

overvoltage condition (OVP) above 10% of the regulated

output voltage will force the top MOSFET off and the bot-

tom MOSFET on until the condition is cleared. An input

4627 F05

TIME

SLAVE OUTPUT

MASTER OUTPUT

OUTPUT

VOLTAGE

electronic circuit breaker or fuse can be sized to be tripped

or cleared when the bottom MOSFET is turned on to pro-

tect against the overvoltage. Foldback current limiting is

disabled during soft-start or tracking start-up.

Run Enable

The RUN pin is used to enable the power module or

sequence the power module. The threshold is 1.25V, and

the pin has an internal 5.1V Zener to protect the pin. The

RUN pin can be used as an undervoltage lockout (UVLO)

function by connecting a resistor divider from the input

supply to the RUN pin:

VUVLO = ((R1+R2)/R2) • 1.25V.

See the Block Diagram for the example of use.

INTVCC Regulator

The LTM4627 has an internal low dropout regulator from

VIN called INTVCC. This regulator output has a 4.7μF

ceramic capacitor internal. This regulator powers the

internal controller and MOSFET drivers. The gate driver

current is ~20mA for 750kHz operation. The regulator loss

can be calculated as:

(VIN–5V)•20mA =PLOSS

EXTVCC external voltage source ≥ 4.7V can be applied to

this pin to eliminate the internal INTVCC LDO power loss

and increase regulator efﬁciency. A 5V supply can be

applied to run the internal circuitry and power MOSFET

driver. If unused, leave pin ﬂoating.

Stability Compensation

The module has already been internally compensated

for all output voltages. Table 4 is provided for most ap-

plication requirements. The Linear Technology μModule

Power Design Tool will be provided for other control loop

optimization.

LTM4627EVPBF Datasheet(PDF) 15 Page - Linear Technology

LTM4627EVPBF Datasheet(HTML) 15 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datasheet Download

Link URL