S-93C46B_1 datasheet(13/50 Pages) SII

13 / 50 page

3-WIRE SERIAL E

2PROM

Rev.7.0_00

S-93C46B/56B/66B

Seiko Instruments Inc.

Writing (WRITE, ERASE, WRAL, ERAL)

A write operation includes four write instructions: data write (WRITE), data erase (ERASE), chip write (WRAL),

and chip erase (ERAL).

A write instruction (WRITE, ERASE, WRAL, ERAL) starts a write operation to the memory cell when a low level

is input to CS after a specified number of clocks have been input.

The SK and DI inputs are invalid during the

write period, so do not input an instruction.

Input an instruction while the output status of the DO pin is high or high impedance (High-Z).

A write operation is valid only in program enable mode (refer to “5. Write enable (EWEN) and write disable

(EWDS)

”).

4. 1

Verify operation

A write operation executed by any instruction is completed within 8 ms (write time tPR: typically 4 ms), so if

the completion of the write operation is recognized, the write cycle can be minimized.

A sequential

operation to confirm the status of a write operation is called a verify operation.

(1) Operation

After the write operation has started (CS

= low), the status of the write operation can be verified by

confirming the output status of the DO pin by inputting a high level to CS again.

This sequence is

called a verify operation, and the period that a high level is input to the CS pin after the write operation

has started is called the verify operation period.

The relationship between the output status of the DO pin and the write operation during the verify

operation period is as follows.

• DO pin = low: Writing in progress (busy)

• DO pin = high: Writing completed (ready)

(2) Operation example

There are two methods to perform a verify operation:

Waiting for a change in the output status of the

DO pin while keeping CS high, or suspending the verify operation (CS

= low) once and then performing

it again to verify the output status of the DO pin.

The latter method allows the CPU to perform other

processing during the wait period, allowing an efficient system to be designed.

Caution 1. Input a low level to the DI pin during a verify operation.

2. If a high level is input to the DI pin at the rise of SK when the output status of the DO pin is

high, the S-93C46B/56B/66B latches the instruction assuming that a start bit has been input.

In this case, note that the DO pin immediately enters a high-impedance

(High-Z) state.

S-93C46B Datasheet(PDF) 13 Page - Seiko Instruments Inc

S-93C46B Datasheet(HTML) 13 Page - Seiko Instruments Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

Datasheet Download

Link URL