ZXLD1322 datasheet(9/17 Pages) DIODES

9 / 17 page

ZXLD1322

Document number: DS32166 Rev. 3 - 2

9 of 17

www.diodes.com

April 2010

A Product Line of

Diodes Incorporated

ADJ pin

The ADJ pin is connected to the internal 500mV reference (VREF) via a 100k resistor. This biases the ADJ pin to the

reference voltage and defines nominal 100% LED current.

The ADJ pin can be overdriven with an external dc voltage between 50mV and 500mV to reduce the LED current

proportionally between 10% and 100% of the nominal value.

LED current can also be adjusted by applying a low frequency PWM signal to the ADJ pin to turn the device On and Off.

This will produce an average output current proportional to the duty cycle of the control signal.

The device can be shut down by shorting the ADJ pin to ground, or pulling it to a voltage below 28mV with a suitable open

collector NPN or open drain NMOS transistor. In the shutdown state, most of the circuitry inside the device is switched off

and residual quiescent current will be typically 12

μA.

Thermal control of LED current

The 'Thermal compensation current' circuit produces a sourcing current (Itc) which is zero for voltages above 75mV on TADJ

and increases to 100

μA when TADJ falls to 50mV. This current is summed into the control node and subtracted from the

demand current, causing LED current to reduce from 100% down to zero over this input range. The potential divider,

consisting of a fixed resistor Rt and an NTC Thermistor Rth between VREF and ground, defines the voltage on TADJ and sets

the threshold temperature. Further details are given in the application notes.

The Thermal Control feature can be disabled by leaving the TADJ pin floating, or by connecting it to VREF.

Over-temperature shutdown

The ZXLD1322 incorporates an over-temperature shutdown circuit to protect the device against damage caused by excess

die temperature, resulting from excessive power dissipation in the switch. The output of the 'Over-temp Shutdown' circuit will

go high when the die temperature exceeds 150°C (nominal). This will turn off the drive to the switch during normal operation.

Operation will resume when the device has cooled to a safe level.

ZXLD1322 Datasheet(PDF) 9 Page - Diodes Incorporated