| Electronic Components Datasheet Search |
|
SX8661 Datasheet(PDF) 68 Page - Semtech Corporation |
|
|
|||||||||||||||||||||||||||||
SX8661 Datasheet(HTML) 68 Page - Semtech Corporation |
|
68 / 88 page ![]() ADVANCED COMMUNICATIONS & SENSING DATASHEET Revision v3.2, January 2011 © 2011 Semtech Corp. www.semtech.com 68 SX8661 Low Power, Capacitive Button Touch and Proximity Controller (8 sensors) with LED Drivers and Analog Output 6 I2C INTERFACE The I2C implemented on the SX8661 is compliant with: - standard (100kb/s), fast mode (400kb/s) - slave mode - 7 bit address (default 0x2B). The default address can be changed in the NVM at address 0x04. The host can use the I2C to read and write data at any time. The effective changes will be applied at the next processing phase (section 3.3). Three types of registers are considered: - status (read). These registers give information about the status of the capacitive buttons, GPIs, operation modes etc… - control (read/write). These registers control the soft reset, operating modes, GPIOs and offset compensation. - SPM gateway (read/write). These registers are used for the communication between host and the SPM. The SPM gateway communication is done typically at power up and is not supposed to be changed when the application is running. The SPM needs to be re-stored each time the SX8661 is powered down. The SPM can be stored permanently in the NVM memory of the SX8661. The SPM gateway communication over the I2C at power up is then not required. The I2C will be able to read and write from a start address and then perform read or writes sequentially, and the address increments automatically. The supported I2C access formats are described in the next sections. 6.1 I2C Write The format of the I2C write is given in Figure 56. After the start condition [S], the slave address (SA) is sent, followed by an eighth bit (‘0’) indicating a Write. The SX8661 then acknowledges [A] that it is being addressed, and the master sends an 8 bit Data Byte consisting of the SX8661 Register Address (RA). The slave acknowledges [A] and the master sends the appropriate 8 bit Data Byte (WD0). Again the slave acknowledges [A]. In case the master needs to write more data, a succeeding 8 bit Data Byte will follow (WD1), acknowledged by the slave [A]. This sequence will be repeated until the master terminates the transfer with the Stop condition [P]. Figure 56 I2C write The register address is incremented automatically when successive register data (WD1...WDn) is supplied by the master. |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |