http://www.optosupply.com

VER A.0

3

D

L

D

OSTBMAS2C2A

Soldering Heat Reliability (DIP):

IR Reflow soldering Profile

· Reflow soldering should not be done more than two times.

· When soldering, do not put stress on the LEDs during heating.

· After soldering, do not warp the circuit board.

· Repairing should not be done after the LEDs have been soldered.

When repairing is unavoidable,

a double-head soldering iron should be used.

It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by

repairing.

LED & Application Technologies