ST10F276E datasheet(183/235 Pages) STMICROELECTRONICS

183 / 235 page

ST10F276E

Electrical characteristics

Doc ID 12303 Rev 3

183/235

Figure 44.

Port2 test mode structure

1 For Port2 complete structure refer also to Figure 44.

This specification is only valid during Reset, or during Hold- or Adapt-mode. Port 6 pins are only affected if they are used

for CS output and the open drain function is not enabled.

The maximum current may be drawn while the respective signal line remains inactive.

The minimum current must be drawn in order to drive the respective signal line active.

The power supply current is a function of the operating frequency (fCPU is expressed in MHz). This dependency is

illustrated in Figure 45 below. This parameter is tested at VDDmax and at maximum CPU clock frequency with all outputs

disconnected and all inputs at VIL or VIH, RSTIN pin at VIH1min: This implies I/O current is not considered. The device is

doing the following:

- Fetching code from IRAM and XRAM1, accessing in read and write to both XRAM modules

- Watchdog Timer is enabled and regularly serviced

- RTC is running with main oscillator clock as reference, generating a tick interrupts every 192 clock cycles

- Four channels of XPWM are running (waves period: 2, 2.5, 3 and 4 CPU clock cycles): No output toggling

- Five General Purpose Timers are running in timer mode with prescaler equal to 8 (T2, T3, T4, T5, T6)

- ADC is in Auto Scan Continuous Conversion mode on all 16 channels of Port5

- All interrupts generated by XPWM, RTC, Timers and ADC are not serviced

10. The power supply current is a function of the operating frequency (fCPU is expressed in MHz). This dependency is

illustrated in Figure 45 below. This parameter is tested at VDDmax and at maximum CPU clock frequency with all outputs

disconnected and all inputs at VIL or VIH, RSTIN pin at VIH1min: This implies I/O current is not considered. The device is

doing the following:

- Fetching code from all sectors of both IFlash and XFlash, accessing in read (few fetches) and write to XRAM

- Watchdog Timer is enabled and regularly serviced

- RTC is running with main oscillator clock as reference, generating a tick interrupts every 192 clock cycles

- Four channels of XPWM are running (waves period: 2, 2.5, 3 and 4 CPU clock cycles): No output toggling

- Five General Purpose Timers are running in timer mode with prescaler equal to 8 (T2, T3, T4, T5, T6)

- ADC is in Auto Scan Continuous Conversion mode on all 16 channels of Port5

- All interrupts generated by XPWM, RTC, Timers and ADC are not serviced

11. The Idle mode supply current is a function of the operating frequency (fCPU is expressed in MHz). This dependency is

illustrated in Figure 44 below. These parameters are tested and at maximum CPU clock with all outputs disconnected and

all inputs at VIL or VIH, RSTIN pin at VIH1min.

12. This parameter is tested including leakage currents. All inputs (including pins configured as inputs) at 0 to 0.1V or at VDD -

0.1V to VDD, VAREF = 0V, all outputs (including pins configured as outputs) disconnected. Furthermore, the Main Voltage

Regulator is assumed off: In case it is not, additional 1mA shall be assumed.

ST10F276E Datasheet(PDF) 183 Page - STMicroelectronics