Product specifications in this catalog are subject to change without notice.Request our product specifications before purchase and/or use. Please use our products based on the information contained in this catalog and product specifications.

Downsized

PSG

PSF

CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS

●

Super low ESR, high ripple current capability

●

Endurance: 2,000 to 5,000 hours at 105

℃

●

●

RoHS Compliant

●

Halogen Free

◆SPECIFICATIONS

(at 20

℃, 120Hz)

(at 105

℃)

(at 20

℃ after 2 minutes)

(at 20

℃, 120Hz)

(at 100kHz)

Category

Temperature Range

Rated Voltage

Capacitance Tolerance

Surge Voltage

Leakage Current

*Note

Dissipation Factor

(tan

δ)

Low Temperature

Characteristics

(Max.Impedance Ratio)

Endurance

Bias Humidity Test

Surge Voltage Test

Failure Rate

Items

-55 to +105

℃

P20% (M)

Rated voltage(V)B1.15

I=0.2CV or 500μA, whichever is greater

Where, I : Leakage current (μA), C : Nominal capacitance (μF), V : Rated voltage (V)

0.12 max.

Z(-25

℃)/Z(+20℃)≦1.15

The following specifications shall be satisfied when the capacitors are restored to 20

℃ after the rated voltage is applied for 5,000 hours

(20V : 2,000 hours) at 105

℃.

Appearance

No significant damage

Capacitance change

≦±20% of the initial value

D.F. (tan

δ)

≦The initial specified value

ESR

≦150% of the initial specified value

Leakage current

≦The initial specified value

The following specifications shall be satisfied when the capacitors are restored to 20

℃ after subjecting them to DC voltage at 60℃,

90 to 95% RH for 1,000 hours.

Appearance

No significant damage

Capacitance change

≦±20% of the initial value

D.F. (tan

δ)

≦The initial specified value

ESR

≦150% of the initial specified value

Leakage current

≦The initial specified value

The capacitors shall be subjected to 1,000 cycles each consisting of charge with the surge voltage specified at 105

℃ for 30 seconds

through a protective resistor(R=1

k

Ω) and discharge for 5 minutes 30 seconds.

Appearance

No significant damage

Capacitance change

D.F. (tan

δ)

ESR

Leakage current

0.5% per 1,000 hours maximum (Confidence level 60% at 105

℃)

Characteristics

*Note : If any doubt arises, measure the leakage current after the following voltage treatment.

Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105

℃.

Z(-55

℃)/Z(+20℃)≦1.25

≦±20% of the initial value

≦The initial specified value

≦150% of the initial specified value

≦The initial specified value

New!

Radial Lead

CAT. No. E1001L

(1/2)