MCP6482-ESLASHMS datasheet(15/50 Pages) MICROCHIP

15 / 50 page

 2012-2013 Microchip Technology Inc.

DS20002322C-page 15

MCP6481/2/4

4.0

APPLICATION INFORMATION

The MCP6481/2/4 family of op amps is manufactured

using Microchip’s state-of-the-art CMOS process and

is specifically designed for low-power, high-precision

applications.

4.1

Inputs

4.1.1

PHASE REVERSAL

The MCP6481/2/4 op amps are designed to prevent

phase reversal when the input pins exceed the supply

voltages.

Figure 2-32

shows

the

input

voltage

exceeding the supply voltage without any phase

reversal.

4.1.2

INPUT VOLTAGE LIMITS

In order to prevent damage and/or improper operation

of these amplifiers, the circuit must limit the voltages at

the input pins (see Section 1.1 “Absolute Maximum

Ratings †”).

The ESD protection on the inputs can be depicted as

shown in Figure 4-1. This structure was chosen to

protect the input transistors against many (but not all)

overvoltage conditions, and to minimize the input bias

current (IB).

FIGURE 4-1:

Simplified Analog Input ESD

Structures.

The input ESD diodes clamp the inputs when they try

to go more than one diode drop below VSS. They also

clamp any voltages that go well above VDD. Their

breakdown voltage is high enough to allow normal

operation, but not low enough to protect against slow

overvoltage (beyond VDD) events. Very fast ESD

events (that meet the specification) are limited so that

damage does not occur.

In some applications, it may be necessary to prevent

excessive voltages from reaching the op amp inputs;

Figure 4-2 shows one approach to protect these inputs.

FIGURE 4-2:

Protecting the Analog

Inputs.

A significant amount of current can flow out of the

inputs when the Common mode voltage (VCM) is below

ground (VSS), as shown in Figure 2-34.

4.1.3

INPUT CURRENT LIMITS

In order to prevent damage and/or improper operation

of these amplifiers, the circuit must limit the currents

into the input pins (see Section 1.1 “Absolute

Maximum Ratings †”).

Figure 4-3 shows one approach to protect these inputs.

The R1 and R2 resistors limit the possible currents in or

out of the input pins (and the ESD diodes, D1 and D2).

The diode currents will go through either VDD or VSS.

FIGURE 4-3:

Protecting the Analog

Inputs.

Bond

Pad

Bond

Pad

Bond

Pad

VDD

VIN+

VSS

Input

Stage

Bond

Pad

VIN–

VDD

MCP648X

VOUT

VDD

OUT

MCP648X

min (R1,R2) >

VSS –min(V1,V2)

2mA

min (R1,R2)>

max(V1,V2)– VDD

2mA

MCP6482-E/MS Datasheet(PDF) 15 Page - Microchip Technology

MCP6482-E/MS Datasheet(HTML) 15 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

Datasheet Download

Link URL