STM32F372CB datasheet(80/128 Pages) STMICROELECTRONICS

80 / 128 page

Electrical characteristics

STM32F37x

80/128

Doc ID 022691 Rev 3

Static latch-up

Two complementary static tests are required on six parts to assess the latch-up

performance:

●

A supply overvoltage is applied to each power supply pin

●

A current injection is applied to each input, output and configurable I/O pin

These tests are compliant with EIA/JESD 78A IC latch-up standard.

6.3.13

I/O current injection characteristics

As a general rule, current injection to the I/O pins, due to external voltage below VSS or

above VDD (for standard, 3 V-capable I/O pins) should be avoided during normal product

operation. However, in order to give an indication of the robustness of the microcontroller in

cases when abnormal injection accidentally happens, susceptibility tests are performed on a

sample basis during device characterization.

Functional susceptibility to I/O current injection

While a simple application is executed on the device, the device is stressed by injecting

current into the I/O pins programmed in floating input mode. While current is injected into the

I/O pin, one at a time, the device is checked for functional failures.

The failure is indicated by an out of range parameter: ADC error above a certain limit (higher

than 5 LSB TUE), out of conventional limits of induced leakage current on adjacent pins (out

of –5 µA/+0 µA range), or other functional failure (for example reset occurrence or oscillator

frequency deviation).

The test results are given in Table 51.

Table 50.

Electrical sensitivities

Symbol

Parameter

Conditions

Class

Static latch-up class

TA +105 °C conforming to JESD78A

II level A

STM32F372CB Datasheet(PDF) 80 Page - STMicroelectronics