AIS328DQ datasheet(21/43 Pages) STMICROELECTRONICS

21 / 43 page

AIS328DQ

Digital interfaces

Doc ID 18160 Rev 3

21/43

CS is the serial port enable and is controlled by the SPI master. It goes low at the start of the

transmission and returns high at the end. SPC is the serial port clock and is controlled by

the SPI master. It is stopped high when CS is high (no transmission). SDI and SDO are,

respectively, the serial port data input and output. Those lines are driven at the falling edge

of SPC and should be captured at the rising edge of SPC.

Both the read register and write register commands are completed in 16 clock pulses or in

multiples of 8 in cases of multiple read/write bytes. Bit duration is the time between two

falling edges of SPC. The first bit (bit 0) starts at the first falling edge of SPC, after the falling

edge of CS, while the last bit (bit 15, bit 23, ...) starts at the last falling edge of SPC, just

before the rising edge of CS.

bit 0: RW bit. When 0, the data DI(7:0) is written into the device. When 1, the data DO(7:0)

from the device is read. In the latter case, the chip drives SDO at the start of bit 8.

bit 1: MS bit. When 0, the address remains unchanged in multiple read/write commands.

When 1, the address is auto-incremented in multiple read/write commands.

bit 2-7: address AD(5:0). This is the address field of the indexed register.

bit 8-15: data DI(7:0) (write mode). This is the data that is written to the device (MSb first).

bit 8-15: data DO(7:0) (read mode). This is the data that is read from the device (MSb first).

In multiple read/write commands further blocks of 8 clock periods are added. When MS bit is

‘0’ the address used to read/write data remains the same for every block. When MS bit is ‘1’

the address used to read/write data is increased at every block.

The function and the behavior of SDI and SDO remain unchanged.

5.2.1

SPI read

Figure 7.

SPI read protocol

The SPI read command is performed with 16 clock pulses. Multiple byte read commands

are performed by adding blocks of 8 clock pulses to the previous one.

bit 0: READ bit. The value is 1.

bit 1: MS bit. When 0, do not increment address; when 1, increment address in multiple

readings.

bit 2-7: address AD(5:0). This is the address field of the indexed register.

bit 8-15: data DO(7:0) (read mode). This is the data that is read from the device (MSb first).

bit 16-... : data DO(...-8). Further data in multiple byte reading.

SPC

SDI

SDO

DO7 DO6 DO5 DO4 DO3 DO2 DO1 DO0

AD5 AD4 AD3 AD2 AD1 AD0

AIS328DQ Datasheet(PDF) 21 Page - STMicroelectronics

AIS328DQ Datasheet(HTML) 21 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43

Datasheet Download

Link URL