TDA7493 datasheet(11/30 Pages) STMICROELECTRONICS

11 / 30 page

TDA7493

Applications information

Doc ID 14570 Rev 6

11/30

Applications information

5.1

Mode selection

Pin STANDBY selects the operating mode, namely standby or play.

In standby mode, all the circuits are turned off and there is very low leakage current.

In play mode, the amplifiers are powered up.

During the turn on/off sequence, there are four operational states: standby, pre-charge,

mute and play. The pre-charge and mute states are two internal transient states to set up

the normal operating condition and to reduce the speaker pop noise.

Note:

An internal pull-down resistor on pin STANDBY ensures that the default mode is standby.

5.2

Gain setting

The close loop gain is set by pins GAIN0 and GAIN1 as shown below in Table 7. The gain

setting is implemented by changing the feedback resistors of the amplifiers.

Note:

Internal pull-down resistors on pins GAIN0 and GAIN1 ensure that the default gain is 6 dB.

Table 6.

Mode selection

Logic level on pin STANDBY

Mode

Standby

1Play

Table 7.

Gain selection

Logic level on pin GAIN0

Logic level on pin GAIN1

Gv (nominal)

006.0 dB

12.0 dB

15.6 dB

18.0 dB

TDA7493 Datasheet(PDF) 11 Page - STMicroelectronics