ACE4054C

500mA/1.5A Standalone Linear Li-Ion Battery Charge

VER 1.2

3

The PROG pin can also be used to switch the charger to shutdown mode by disconnecting the program

resistor from ground. This results in a 3

μA current to pull the PROG pin to a high level shutdown threshold

voltage, thus stop the charging and reduce the supply current to 25μA. This pin is also clamped to

approximately 2.4V. A higher voltage beyond this value will draw currents as high as 1.5mA. Device

normal operation can be resumed by reconnecting the RPROG resistor to ground.

Ordering information

ACE4054C XX +

H

Block Diagram

Pb - free

GM : SOT-23-6

IM : ESOP-8

Halogen - free