3220 Commander Drive, Suite 102 Carrollton, TX 75006

www.PickerComponents.com

Sales: (972) 713-6272

(888) 997-3933

Fax: (972)735-0964

e-mail: sales@pickercomponents.com

Dimensions are listed for reference purposes only.

Specifications and Availability subject to change without notice.

PCS4 Rev A 8/4/15

2 of 2

PCS4

PCS4

DIMENSIONS (mm/inches)

PRECAUTIONS

1.

Soldering must be completed within 10s at 260* or less or within 5s at 350* or less.

2.

The SSR case serves to dissipate heat. Install the relays so that they are adequately ventilated. If poor ventilation is unavoidable, the load current must be

reduced. Please refer to the curve of "Max. Load current Vs. Ambient Temperature".

3.

The input circuitry does not incorporate a circuit protecting the SSR from being damaged due to a reversed connection. Make sure that the polarity and the

input and output are correct when connecting.

4.

If the output transient voltage exceeds the nominal value a varistor should be mounted on the SSR output terminal in parallel to prevent the relay being

breakdown. The recommended varistor voltage 470V.

5.

When using the relay in phase control applications, at a phase control angle close to 180 degrees the relay's input signal turn off at the trailing edge of the

AC sine wave must be limited to end 200*s before AC zero cross. This assures that the relay has time to switch off. Shorter times may cause loss of con-

trol at the following half cycle.

Max. Permissible Non-repetitive Peak Surge Current vs. Continuance Time

ITSM(A)

Max. Load Current vs. Ambient Temperature

CHARACTERISTIC CURVES

Ambient Temperature (C)

Energizing Continuance Time (ms)

T Type

M Type

Outline Dimensions

PCB Layout

(Bottom View)

 

Wiring Diagram

K Type