MITSUBISHI MICROCOMPUTERS

M35052-XXXSP/FP

SCREEN CHARACTER and PATTERN DISPLAY CONTROLLERS

41

Customer s Parts Number

Note: The fonts and size of characters are standard Mitsubishi type.

Mitsubishi IC catalog name and Mitsubishi lot number

Notes 1 : The mark field should be written right aligned.

2 : The fonts and size of characters are standard Mitsubishi

type.

3 : Customer s Parts Number can be up to 10 characters: Only

0 to 9, A to Z, +, -, /, (, ), &, ', . (period), and , (comma) are

usable.

4 : If the Mitsubishi logo

is not required, check the box be-

low.

Mitsubishi logo is not required

20P2Q-A (20-PIN SSOP) MARK SPECIFICATION FORM

Mitsubishi IC catalog name

Please choose one of the marking types below (A, B, C), and enter the Mitsubishi IC catalog name and the special mark (if needed).

B. Customer s Parts Number + Mitsubishi IC Catalog Name

Mitsubishi IC catalog name

Mitsubishi IC catalog name

Note 1 : If the Special Mark is to be Printed, indicate the desired

layout of the mark in the left figure. The layout will be du-

plicated as close as possible.

Mitsubishi lot number (4-digit) and Mask ROM

number (3-digit) are always marked.

2 : If the customer s trade mark logo must be used in the

Special Mark, check the box below.

Please submit a clean original of the logo.

For the new special character fonts, a clean font original

(ideally logo drawing) must be submitted.

Special logo required

Special Mark (Customer s Trade Mark)

Mitsubishi IC catalog name

Mitsubishi lot number

(6-digit or 7-digit)

10

1

20

11

10

1

20

11

ROM number (3-digit)

Mitsubishi lot number (4-digit)

10

1

20

11

A. Standard Mitsubishi Mark

C. Special Mark Required