ML6460CS datasheet(24/30 Pages) MICRO-LINEAR

24 / 30 page

ML6460

MODE PRESET1

PRESET0

CNTR

CPC

CPS

XXXXXXXX

09080209

1C080209

11080209

Mode Description

Mode A:

All register contents are programmed through serial interface.

Mode B:

Master mode, CCIR656 rate, analog blanking.

Mode C:

Slave mode, SAV and EAV codes, CCIR656 rate, digital blanking.

Mode D:

Slave mode, external sync at start of line, Square pixel rate, analog blanking

Table 8. Preset Modes and Register Values

PRESET PIN CONTROL

The ML6460 can be controlled by a pair of preset mode

pins. These pins do not allow access to all of the

programmable features of the ML6460, but are intended

to provide a simpler interface for most applications. Refer

to Table 8 for preset modes.

SERIAL BUS OPERATION

The serial bus control in the ML6460 has two levels of

addressing: Device Addressing and Functional Addressing.

Device Addressing

: Figures 15, 16, and 17 show the

physical waveforms generated in order to address the

ML6460. There are six basic parts of the waveform:

1. Start Indication: Clock Cycle 0

2. Device Address Shifted in: Clock Cycle 1 through 8

3. Device Address Strobed and Decoded: Clock Cycle 9

4. Function Address Shifted in: Clock Cycle 10 through 17

5. Function Address Strobed and Decoded: Clock Cycle 18

6. Data Shifted in 8 bits at a time, MSB first: Clock

Cycle 19 through 26

7. Data Shifted: Clock Cycle 27

8. Repeat strep 6 & 7 until all data is clocked in.

9. Stop indication: After Last Clock Cycle

(54 for CC, 54 for CNTR)

Note: data at SDATA is ignored at steps 3, 5, and 7.

Device & Function Addressing

: Figures 15, 16, an17

show the register address procedure of the ML6460.

FUNCTIONAL DESCRIPTION (Continued)

Device Address (8 bit)

1011 0100 (Hex = B4)

Function Address (8 bit)

Closed Caption Data Registers (CC): 0000 0000 (Hex = 00)

Macrovision Control Registers (CPC): confidential

Macrovision Data Registers (CPS): confidential

Control Registers (CNTR): 0000 0011 (Hex = 03)

Number of Data Bits

Closed Caption Data Registers (CC): 4 x 8 bits

Macrovision Control Registers (CPC): confidential

Macrovision Data Registers (CPS): confidential

Control Registers (CNTR): 4 x 8 bits

CONTROL REGISTER DEFAULT SETTINGS

At Power up, the ML6460 default settings are as follows:

•

Control Register is undefined when the serial

bus mode is enabled.

•

Macrovision Register is automatically

configured by the Macrovision default

values.

•

Chip is ready to process video

•

Preset Pins are available and if used will

configure the control register.

•

Must write logic “0” (zero) to A30 to get

video

To get black at power up will require logic “1” in A30.

X = don't care

* = confidential information

ML6460CS Datasheet(PDF) 24 Page - Micro Linear Corporation

ML6460CS Datasheet(HTML) 24 Page - Micro Linear Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Datasheet Download

Link URL