R5975D datasheet(40/47 Pages) STMICROELECTRONICS

40 / 47 page

Application information

R5975D

40/47

DocID026878 Rev 1

8.9

Synchronization example

See Section 5.3 on page 12 for details.

Figure 26. Synchronization example

8.10

Compensation network with MLCC at the output

The R5975D standard compensation network (please refer to Figure on page 2 and

Section 7 on page 19) introduces a single zero and a low frequency pole in the system

bandwidth, so a high ESR output capacitor must be selected to compensate the 180-degree

phase shift given by the LC double pole.

The selection of the output capacitor must guarantee that the zero introduced by this

component is inside the designed system bandwidth and close to the frequency of the

double pole introduced by the LC filter. A general rule for the selection of this compound for

the system stability is provided in Equation 51.

Equation 51

MLCCs (multiple layer ceramic capacitor) with values in the range of 10 µF - 22 µF and

rated voltages in the range of 10 V - 25 V are available today at relatively low cost from

many manufacturers.

These capacitors have very low ESR values (a few m

) and are therefore occasionally

used for the output filter in order to reduce the voltage ripple and the overall size of the

application.

However, the zero given by the output capacitor falls outside the designed bandwidth and so

the system becomes unstable with the standard compensation network.

fZ ESR

 ESR C

OUT





------------------------------------------------

bandwidth



fLC f



Z ESR

10 fLC





R5975D Datasheet(PDF) 40 Page - STMicroelectronics

R5975D Datasheet(HTML) 40 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47

Datasheet Download

Link URL