M95040-DRMN8TP datasheet(10/39 Pages) STMICROELECTRONICS

Part #	M95040-DRMN8TP

Description	4-Kbit serial SPI bus EEPROM - 105 C Operation

PDF	39 Pages

Scroll/Zoom	100%

Manufacturer	STMICROELECTRONICS [STMicroelectronics]

Direct Link	http://www.st.com

Logo

10 / 39 page

Operating features

M95040-DRE

10/39

DocID027516 Rev 1

Operating features

3.1

Active power and Standby power modes

When Chip Select (S) is low, the device is selected and in the Active power mode.

When Chip Select (S) is high, the device is deselected. If a Write cycle is not currently in

progress, the device then goes in to the Standby power mode, and the device consumption

drops to ICC1, as specified in Table 11.

3.2

SPI modes

The device can be driven by a microcontroller with its SPI peripheral running in either of the

two following modes:

•

CPOL=0, CPHA=0

•

CPOL=1, CPHA=1

For these two modes, input data is latched in on the rising edge of Serial Clock (C), and

output data is available from the falling edge of Serial Clock (C).

The difference between the two modes, as shown in Figure 3, is the clock polarity when the

bus master is in Stand-by mode and not transferring data:

•

C remains at 0 for (CPOL=0, CPHA=0)

•

C remains at 1 for (CPOL=1, CPHA=1)

Figure 3. SPI modes supported

M95040-DRMN8TP Datasheet(PDF) 10 Page - STMicroelectronics