Note 3: The human body model is a 100 pF capacitor discharged through a 1.5k

Ω resistor into each pin. The machine model is a 200pF capacitor discharged

directly into each pin.

Note 4: All limits guaranteed at room temperature (standard typeface) and at temperature extremes (bold typeface). All room temperature limits are 100%

production tested. All limits at temperature extremes are guaranteed via correlation using standard Statistical Quality Control (SQC) methods. All limits are used to

calculate Average Outgoing Quality Level (AOQL).

Note 5: Typical numbers are at 25˚C and represent the most likely norm.

Note 6: Duty cycle affects current limit due to ramp generator.

Note 8: Bias current flows into FB pin.

Note 9: Junction to ambient thermal resistance (no external heat sink) for the MSO8 package with minimal trace widths (0.010 inches) from the pins to the circuit.

See ’Scenario ’A’’ in the Power Dissipation section.

Note 10: Junction to ambient thermal resistance for the MSO8 package with minimal trace widths (0.010 inches) from the pins to the circuit and approximately

0.0191 sq. in. of copper heat sinking. See ’Scenario ’B’’ in the Power Dissipation section.

Note 11: Junction to ambient thermal resistance for the MSO8 package with minimal trace widths (0.010 inches) from the pins to the circuit and approximately

0.0465 sq. in. of copper heat sinking. See ’Scenario ’C’’ in the Power Dissipation section.

Note 12: Junction to ambient thermal resistance for the MSO8 package with minimal trace widths (0.010 inches) from the pins to the circuit and approximately

0.2523 sq. in. of copper heat sinking. See ’Scenario ’D’’ in the Power Dissipation section.

Note 13: Junction to ambient thermal resistance for the MSO8 package with minimal trace widths (0.010 inches) from the pins to the circuit and approximately

0.0098 sq. in. of copper heat sinking on the top layer and 0.0760 sq. in. of copper heat sinking on the bottom layer, with three 0.020 in. vias connecting the planes.

See ’Scenario ’E’’ in the Power Dissipation section.

Typical Performance Characteristics

Efficiency vs. Load Current

(V

Efficiency vs. Load Current

(V

10127326

10127325

Switch Current Limit vs. Temperature

(V

Switch Current Limit vs. V

IN

10127320

10127322

www.national.com

5